Curls, Spiral Curls and Lift Curls

Spiral Curls

Just after being curled:

Once they had been dressed out:

Process:

• Begin by sectioning the hair and clipping strands out of the way if they are not being used.
• Then taking a single section, hold the curling iron in a downwards angle and wrap the hair around it with the ends of the hair at the bottom of the wand.
• Repeat using another section, however wrapping it the opposite way around the wand (but with the end of the hair still at the bottom of the wand) doing this will avoid the hair all curling into one piece. 
• Using different sections complete all of the hair and then leave to set.
• Once the hair has been left to set, begin to dress the hair and slightly combing out the curls so that they become loose and not as harshly sectioned. 

Lift Curls

Just after being curled:

Once they have been dressed out:

Process:

• Begin by sectioning the hair and clipping strands out of the way if they are not being used.
• Holding the wand horizontally to head. Then wrap a sectioned piece of hair around the wand and begin rolling it under and close to the head. Then clip into place using a sectioning clips. This piece should look like a barrel and like a tube.
• Repeat all over the head. And then leave to set for a while e.g 15 minutes for them to set properly. 
• Then release the curls from the sectioning clips and loosen them slightly, using the end of a pintail comb preferably.